%0 Journal Article %T Realization of a 3.3V battery-free DC power supply with photovoltaic energy harvester and supercapacitor storage for the supply of a low consumption wireless sensor %T Réalisation d'une alimentation DC 3,3V sans pile avec récupération d'énergie photovoltaïque et stockage sur supercapacités pour l'alimentation d'un capteur sans fil basse consommation %+ Service Instrumentation Conception Caractérisation (LAAS-I2C) %+ Équipe Énergie et Systèmes Embarqués (LAAS-ESE) %A Séguier, Lionel %A Boitier, Vincent %A Huet, Florian %A Dilhac, Jean-Marie %A Caignet, Fabrice %Z projet 2ido %< avec comité de lecture %Z Rapport LAAS n° 20091 %@ 1252-770X %J La Revue 3 E. I %I Société de l'électricité, de l'électronique et des technologies de l'information et de la communication %N 101 %P 13-24 %8 2020-07 %D 2020 %K WSN %K energy harvester %K photovoltaïque %K récupération énergie %K supercapacité %Z Engineering Sciences [physics]/Electronics %Z Engineering Sciences [physics]/Electric powerJournal articles %X This article deals with the sizing, the characterization and operation of a low cost power supply ,3.3 V 200 mA, without battery, intended for the supply of low consumption wireless sensor nodes over very long durations. A SPV1050 circuit recovers the electrical energy from a photovoltaic panel (5x7 cm²), stores it on two supercapacities in series (12.5 F, 5.2 V), then shapes it with an internal LDO to provide the requested voltage. The problem of a too long initial start-up time for the supercapacity circuits initially discharged is solved in an original way thanks to a preload and a control of the start-up. %X Cet article développe le dimensionnement, la caractérisation et la mise en fonctionnement d'une alimentation à faible coût ,3,3 V 200 mA, sans pile, destinée à l'alimentation de noeuds de capteurs sans fil à faible consommation sur de très longues durées. Un circuit SPV1050 récupère l'énergie électrique issue d'un panneau photovoltaïque (5x7 cm²), la stocke sur deux supercapacités en série (12,5 F, 5,2 V), puis la met en forme avec un LDO interne afin de fournir la tension demandée. Le problème lié à la durée trop grande du démarrage initial pour les circuits à supercapacités initialement déchargées est solutionné de façon originale grâce à une précharge et à un contrôle de la mise en fonctionnement. %G French %2 https://laas.hal.science/hal-02651454/document %2 https://laas.hal.science/hal-02651454/file/article_Photovolta%C3%AFque.pdf %L hal-02651454 %U https://laas.hal.science/hal-02651454 %~ UNIV-TLSE2 %~ UNIV-TLSE3 %~ CNRS %~ INSA-TOULOUSE %~ LAAS %~ UT1-CAPITOLE %~ LAAS-ESE %~ LAAS-I2C %~ LAAS-GESTION-DE-L-ENERGIE %~ INSA-GROUPE %~ INSA-TOULOUSE-GEI %~ TOULOUSE-INP %~ UNIV-UT3 %~ UT3-INP %~ UT3-TOULOUSEINP